Using Cisco Mini USB Console Cable to Configure Cisco Switches and Routers

Cisco Device Mini USB Port

Cisco has added mini usb port into their products for many years.

The key to use this port is to get a right cable. At most situations we are using regular RJ45 console port with a USB to Serial Adapter connecting to your computers. Occasionally, you may need to have another console access for your multiple person’s troubleshooting console access. Some devices may still have AUX port. For 2960x switches, AUX port is gone.

RJ-45 Console Cable with USB Adapter

If you would like to use mini usb port, you will have to find a USB to mini usb cable such as below.

Cisco Mini USB Console Cable

Cisco Router’s Back Ports

Cisco Mini USB Console Cable connecting Cisco Router to Laptop

2. Install Cisco USB Console drivers on your computer:
You may need to reboot your computer.

3. Confirm the COM port number:
In this case, it is using COM6 port.

4. Set up Serial access using PuTTy

5. Console Outputs once connected successfully.

Notes:

1. USB console is taking precedence before Rj45 console access for input.
2. Update Driver manually if it is not working properly.

Related

Cisco Switch 2960 / 3560 Password Recovery Procedures

Worked on a used cisco switch 2960 which has been configured password. Following steps have been recorded how to get into recover mode.1. Connect Console CableCisco provides a couple of ports for console access, such as Console port, Mini USB port, AUX port. I has a previous post "Using Cisco…

Comparison of Cisco Switches: (2960 vs 3560), (Cisco 3560 X vs 3650 vs 3750-X vs 3850)

For Branch Routers, please check Comparison of Cisco Integrated Services Routers: (1800,2800,3800) vs (1900,2900,3900) vs 4000Cisco 2960 vs 3560 Switch2960 series switches are L2 only switches. Meaning that you can setup VLANs but you won't be able to route between then. 3500 series switches are L3 switches. Hence you will be…

Cisco Switchport Mode Best Practices

For Access Mode: switchport mode accessswitchport nonegotiateswitchport access vlan 100For Trunk Mode:switchport trunk encapsulation dot1qswitchport mode trunkswitchport nonegotiateswitchport trunk allowed vlan 10,100switchport trunk native vlan 1The reason why switch port can automatically form trunk is because of DTP (Dynamic Trunk Protocol).For access layer switches, default configuration is switchport mode dynamic auto…